End Caps For Dishwasher Basket – Repair Kit 50 Pcs.

This dishwasher basket repair kit contains 50 end caps for rods where the original coating is worn, cracked or missing. The caps cover the exposed end and create a smoother contact surface around the tips of the basket. They can be used in both the upper and lower basket when the measurements fit.

Each cap is approximately 25.4 mm long and has an outer diameter of approximately 5.2 mm. The inner opening is approximately 3 mm. Therefore, check the basket’s rods before ordering, as the fit depends on the rod’s diameter and the remaining coating.

Key Benefits

• The package contains 50 end caps for multiple repair areas.
• Covers worn or exposed ends on the basket’s rods.
• Creates a smoother finish around exposed metal tips.
• Installed by twisting and pushing the cap into place.
• Does not require screws, tools or replacement of the entire basket.
• Made from ABS plastic for use in the dishwasher basket.
• Can be used on compatible rods in both baskets.
• The many parts allow for ongoing replacement of caps.

For Worn Rods In The Dishwasher Basket

The coating on a dishwasher basket can become worn over time at the exposed rods. When the metal becomes visible, the end can feel rough and be more susceptible to further damage. An end cap covers the defined area and gives the rod a rounded finish.

The caps are intended for minor repairs on otherwise usable baskets. They do not rebuild a bent rod and do not replace missing parts of the basket’s construction. If the metal is heavily corroded, loose or eaten away, the basket should be assessed and possibly replaced.

Check The Diameter Before Installation

The inner opening measures approximately 3 mm. A rod that is significantly thicker may damage the cap during installation, while a significantly thinner rod may result in a loose fit. Therefore, measure the cleaned rod and compare it with the cap’s inner diameter.

The outer diameter of approximately 5.2 mm provides a wider surface than the inner opening. The length of approximately 25.4 mm means that the cap covers a piece down along the rod. Ensure there is space around the rod so that the basket’s moving parts and dishes are not hindered.

Installation Without Tools

Remove loose debris from the damaged tip, and clean the area before installation. The rod should be dry and free from loose rust material. Place the cap’s opening over the tip, and gently twist it down until it sits securely. The product material shows installation with a slight screwing motion.

Do not use excessive force. If the cap cannot be pushed on, it should be removed, and the diameter checked again. After installation, the cap should fit securely without wobbling or sliding off. Check the fit again after the first washes.

Measurements And Specifications

How To Install The End Caps

1. Remove the basket if it makes the work area easier to reach.
2. Remove loose coating debris and loose rust material from the tip.
3. Clean and dry the part of the rod that needs to be covered.
4. Place the cap’s opening directly over the metal tip.
5. Twist and gently press the cap down until it sits securely.
6. Check that the cap does not touch dishes or moving parts.

Inspection And Maintenance

Regularly inspect the caps, especially after the first washes. Replace a cap if it becomes loose, cracks or no longer covers the damaged area. Remove loose caps from the machine to prevent them from ending up in the filter or pump.

The package contains 50 end caps. Dishwasher basket, tools and other parts are not included. The kit is intended for ongoing maintenance of compatible basket tips and should not be used as a replacement for a structurally damaged basket.