Self-Adhesive Hair Filter For Drains – 2 Metre Roll

This self-adhesive hair filter for drains is designed to collect hair before it accumulates in the drain. The filter comes as a roll of fine mesh that can be cut to the desired length and shape. This allows for a customised solution for various floor drains in showers, bathrooms, and other wet areas. The mesh allows water to pass through while the hair remains on the surface, making it easier to remove.

Key Benefits

• Fine mesh helps to catch hair around the drain.
• The roll can be cut to fit the size and shape of the drain.
• Self-adhesive edges make installation simple without screws.
• Water can still flow through the small openings in the mesh.
• Supplied on a 200 cm long roll for multiple cuts.
• Included scraper can be used for installation and removal.

Overview

This self-adhesive drain filter against hair is a practical solution for the ongoing maintenance of drains. Instead of a filter with a fixed shape, the product is supplied on a roll, allowing you to measure, cut, and customise a piece for the specific drain. It is useful for long floor drains, square drains, or other shapes where a standard round hair filter does not fit.

The filter’s mesh structure retains hair while allowing water to flow through the openings. When hair has accumulated on the mesh, the used piece can be pulled off and disposed of. A new piece can then be cut from the roll and installed. The product helps to reduce the amount of hair that goes directly down the drain.

Dimensions and Specifications

How to Measure and Customise the Filter

Start by measuring the part of the drain that the filter needs to cover. Then cut a suitable piece from the roll with scissors. The piece should be long enough to cover the opening and allow the self-adhesive edges to make contact with the surface. For drains with a special shape, the mesh can be cut further to follow the area around the grate.

Avoid placing the adhesive parts directly over openings where water needs to flow down. The mesh should cover the drain while the edges adhere to the surface around it. Check the placement before removing the protective layer, as repeated moving can reduce the adhesive ability.

Installation on a Clean and Dry Surface

First, wipe away water, soap residue, and dirt from the area around the drain. The surface must be clean and completely dry before the filter is applied. Remove the protective layer from the edges, place the mesh over the drain, and press the edges evenly against the substrate. Ensure that the entire edge has contact with the surface so that water does not lift the filter during use.

The product is best suited for smooth surfaces where the adhesive material can bond properly. Grout, rough tiles, unevenness, and persistent moisture can make the installation less stable. Therefore, test the placement before the area is put into regular use.

Replacement and Cleaning

Regularly check the mesh and remove collected hair to keep the passage of water clear. When the filter is full or no longer adheres securely, it can be pulled off and replaced with a new piece from the roll. The included scraper can be used to gently loosen the filter or remove any adhesive residue. Work carefully to avoid scratching the substrate.

Practical Maintenance of the Drain

The cuttable roll allows for the creation of multiple filters in the size that fits each drain. The combination of mesh, self-adhesive installation, and flexible customisation makes the product suitable for regular use, where loose hair often ends up around the drain. The filter does not replace regular cleaning of the grate and drain but makes the daily collection of hair more manageable.